Mfinity Ceramic Coating for Vinyl Wrapis great for those looking to protect and enhance their vehicle's vinyl wrapped surface. MFinity Wrapcan remain durable for up to 2 years. Wrap will make cleaning easier and will protect from contaminants and ultraviolet damage. Like all MFinity products, Wrap is very user-friendly. This coating leaves matte vinyl with a dulled appearance while enhancing gloss finishes.
Wrap was formulated to be used to protect the vinyl wrap and paint protection surfaces.
Reduces orange peel
UV resistant & weather resistant
Enhances the color & finish
Extends the lifespan of the film
A 50 ML bottle can coat 4 to 7 sedans with a gloss finish wrap, 3 to 5 sedans with a satin finish wrap, or 2 to 3 sedans with a matte finish wrap.
Safety Instructions: 1. Keep out of reach of children 2. Store at a cool dry place (<75 ºF) 3. Don't Mix with other products 4. Use a respirator and gloves during application
Prepare the surface of your vehicle. Go over the surface with denatured alcohol to remove any residual oils.
Use a MFinity Applicator block with a Mfinity Microsuede Applicator wrapped around or the MFinity Pro Microfiber Applicator.
Shake the product well. Apply 6 to 8 drops to the applicator. Coat the entire pad so it is dampened with the coating.
Coat the entire panel in horizontal and vertical strokes. Make sure to coat the entire surface.
After 60 seconds smooth over the surface with a clean microfiber cloth using the same application technique and light, even pressure to remove any residual coating
Repeat step 5 after approximately 10 seconds with a second clean MFinity microfiber cloth to smooth out the surface.
Let cure for 30 minutes or less before next coating
If and when applying a second coat, use 2 - 3 drops of MFinity Wrap on the applicator pad.
Wrap will harden within 8 - 12 hours. However, full cure time is 3 to 4 days depending on weather conditions and temperature.
Wait at least 7 days after coating the surface before exposure to water, dirt, cleaners, or any other contaminants. Failure to do so may result in streaking and or staining.
Due to rapid hardening, it is recommended to apply in smaller surface areas rather than one large section.
Ensure that you are using clean microfiber cloths for each step, and do not reuse suede applicators.
Make sure to keep the coated vehicle out of wet conditions while curing.
When maintaining and cleaning the vehicle, use a neutral PH soap to ensure longevity.
Only use touchless washes on your ceramic coated surfaces.
There is no need to wax the surface of your vehicles after coating has been applied.
Store all coatings in a cool, dry place.
Shelf life for an unopened bottle is 2 years.
Use within 6 months after opening.
Wipe drip tip after use and seal tightly to prevent clogging.
Do not refrigerate or freeze ceramic coatings.
WARNING: KEEP OUT OF REACH OF CHILDREN. USE IN WELL VENTILATED AREAS ONLY!
Always read instructions before use. May be harmful if swallowed. May cause skin & eye irritation. If swallowed please contact the poison control center or physician immediately. In case of eye contact, immediately flush with water, remove any contact lenses, continue flushing with water for 10 minutes. If irritation continues, acquire medical advice/attention.